MoreExam
1. Question Content...
EXPLANATION
Answer: X - EXPLANATION Content.
Question1: In which two locations would you find the WWPNs for a Windows host? (Choose two.)
Question2: Where would you find the version of the driver and firmware for QLogic HBAs that are supported by NetApp E-Series systems?
Question3: Click the Exhibit button.Referring to the exhibit, which cable is an InfiniBand 4X connector?
Question4: What is represented by the Headroom graph on the SANtricity System Manager performance tab?
Question5: Which two steps are required to enable multifactor authentication on an E-Series system? (Choose two.)
Question6: A customer has launched a data analytics initiative and has been transferring old data into the new data lake.The customer has discovered some data read errors during the transfer process.In thisscenario, how should the customer have avoided these data integrity issues?
Question7: Which two errors would fail a pre-upgrade health check? (Choose two.)
Question8: A customer needs toadd an EF280 with FC into its existing Brocade fabric but the FC ports in the SANtricity System Manager are showing the FC ports as down and the LED on the FC HIC is amber.Which three tasks does the installer need to complete to solve this problem? (Choose three.)
Question9: A customer wants to manage an E-Series system over a secure connection between the system and a server.During implementation, you are asked to fulfill this installation requirement.In this scenario, which three actions are required to complete this task? (Choose three.)
Question10: You are adding drives to an existing Dynamic Disk Pool (DDP).In this scenario, which two drive characteristics should you consider whenselecting the drives? (Choose two.)
Question11: Which alerting method would be configured using the SANtricity System Manager setup wizard?
Question12: When a drive fails in a Dynamic Disk Pool (DDP) with no free capacity, what happens to the data?
Question13: Which file contains the configuration for a multipath driver for FC on Linux systems?
Question14: Which data protection strategy has the most overhead capacity as a percentage of the total capacity?
Question15: A company has a duplex E-Series system that is operating in a highly tuned environment. Load distribution between the controllers has been manually set up to achieve a specific distribution based onunique workload characteristics.In this scenario, to maintain this load distribution over time, which E-Series feature should be disabled?
Question16: Click the Exhibit button.Acustomer's host is running a Red Hat Enterprise Linux 7.6 server with dm-mp configured for ALUA and is connected to a single volume on the EF280 system that is shown in the exhibit.In this scenario, how many active/optimized paths are available to the volume?
Question17: What are two methods for setting the host protocol configuration on the E2800 controller with a 4-port 16Gbps FC or 10Gbps iSCSI SFP+ host interface card (HIC)? (Choose two.)
Question18: A customer is running several EF570 systems and uses the ability of the EF-Series systems to run two host protocols at the same time. You are installing a new EF570 thatuses the NVMe protocol for a high performance computing application. The controller on-board ports will not connect, but the HIC ports are working fine.In this scenario, what is the problem?
Question19: A company wants the most scalable host-side connection topology for E-Series systems.In this scenario, which FC topology would satisfy the requirement?
Question20: Which iSCSI setting would you change from its default value to increase the throughput of an iSCSI host port on a NetApp E-Series system?
Question21: Your company has deployedan E2824 and has decided to change the host protocol from iSCSI to FC. You use the storage array profile to review the installed SFPs.In this scenario, which set of supported data rates indicates that you are using dual-purpose SFPs?
